Power Steering Cooler for Autocross Competitions

This will require some fabrication work. I made my own aluminum power steering cooler mount bracket. 


I fabricated this mount from a piece of 1/8th inch aluminum flat stock. Buffed it a little and put holes in for air flow. 


This is the finished mount point


Now I didn't find anything I liked for a cooler so I found a big trans cooler and I tapped into the low volume side of the power steering  unit. In autocross you are constantly going through winding turns and this is very hard on the power steering units. Temperature rises to point of boiling out your power steering fluid, so a little prep work can go a long way in helping you prevent buying a new power steering unit. 


No comments: